LENS INSTALLATION - How to Install Replacement Lenses

Full Frame Sunglasses

1. Grip the top and bottom of the frame with both hands.

2. Gently pull up on the top of the frame while pushing the lens out from the back.

3. Insert the replacement lens starting at the nose bridge.

4. Press the replacement lens along the perimeter until it snaps securely into place.

Half Frame Sunglasses

1. Grip the top of the frame at the nose bridge with one hand and the lens with the other.

2. Pull the lens tab out of the frame's nose socket to remove the lens.

3. Insert the outer replacement lens tab into the frame's temple socket.

4. Snap the inner lens tab into the nose socket to secure the replacement lens into place.

Wire Frame Sunglasses

1. Loosen the screw on the outer edge of the lens by the frame's temple.

2. Remove the lens after the screw is loose.

3. Insert the replacement lens into the grooves in the metal frame.

4. Tighten the screw back down to secure the lens.

Shield Frame Sunglasses

1. Remove the nosepiece by squeezing it towards the center.

2. Pull up on the frame while pulling down on the lens to dislodge it.

3. Slide the new lens into a corner, bend and insert the other side into the opposite corner.

4. Push up on the lens until it pops into place and slide on the nosepiece.